E3d revo ender 3 v2 upgrade#
E3d revo ender 3 v2 pro#
E3d revo ender 3 v2 series#

E3d revo ender 3 v2 upgrade#

I am aware that this is a $75 upgrade for a $200 printer, but in this specific case, all of the 3D printers have been sold out in stores and online for at least two weeks, and this upgrade is a reliable way to double my throughput. I chose not to go that route because I have experience with the E3D products, and like to keep all of my machines running as many of the same components as possible. With the upgraded hot end I am able to produce two headbands in about three hours, and I think I can improve on that eventually.Īs a talking point, I realize that a more simple solution exists in the microswiss all metal hot end upgrade that is made specifically for the Ender 3, and that particular upgrade does not involve changing any of the stock fan shrouds or ducts. My previous print time for two Prusa RC3 style headbands was around 6 hours using the stock hot end. I have been successful with decreasing my print times using this new setup. I have now fully completed the installation of the Bullseye hot end using the E3D V6. The following is a step by step account of my upgrade, with pictures. My solution was to replace the Ender 3 stock hot end with the popular E3D V6 all metal hot end, and use a 0.8mm nozzle to speed print times up. Also of note, is that these are structural parts that do not require any detail. While it is safe to operate the hot end at 240C, this is the low end of the PETG workable temperature range, and I found it to be a rate limiting factor when trying to cut down print times. This design works very well for filaments with lower working temperatures, mainly PLA and ABS. Creality sells the stock hot end that comes on the Ender 3 as the popular style where the PTFE tube runs all the way through the melt zone and butts up against the nozzle. The filament of choice is PETG, which requires a hot end temperature of 235 to 260 degrees C. The entire installation process takes about 30 minutes, and no firmware modifications are required.My friend Dan picked up several Ender 3 3D Printers in late March 2020 to help fight COVID-19, and I volunteered to run two of them to create face shields for health care workers and first responders. I really like my Hemera XS, but I don't care for the available Ender mounting methods so far.

E3d revo ender 3 v2 pro#

The Revo V6 on my Ender 5 Plus, a Revo Hemera XS on my 2nd E3 Pro and now the Revo CR on my 1st E3 Pro with MSDD. The kit includes everything needed to upgrade your printer to a lightweight direct drive system with a Revo hotend, and it comes with solderless, crimpless, butt splice connectors for easy heater cartridge and thermistor connections. Also, I'd like to report that I'll be running 3 versions of this now.

E3d revo ender 3 v2 series#

It is a true drop-in replacement for the CR-10 and Ender 3 series of printers (please see fitment tab for details). This extruder allows for seamless integration of RapidChange Revo technology with the Micro Swiss NG™ extruder line. This high-quality extruder is designed with both reliability and efficiency in mind, combining the best of both E3D and Micro Swiss technology. Micro Swiss NG REVO Extruder is the result of a collaboration between two leading 3D printing companies - Micro Swiss and E3D. Micro Swiss NG™ REVO Direct Drive Extruder